Primary Navigation
Natural Gas Engines
Below are areas to look at when you note problems with natural gas engines. This type of engine must be handled differently than their diesel engine counterparts. When looking for a reason of failure we must play detective and rule out the possibilities. When looking at a problem with this type of engine think about the following:
- If you note electrical pitting in the bearings and crankshaft area look on the oil side. This type of pitting usually indicates the electrical current flowing through the oil. You usually will not see the electrical ground problem on the coolant side.
- It is important to know at what temperature the engine is running. Standby engines sit cold and when they are brought up to engine temperature the temperature must be above 190°F to burn off any moisture. If the engine is allowed to run cold is has a tendency to make nitric acid.
- It is important to check the oil samples to see what the sulfate and nitrites are doing. If they are high, this is a good indication of combustion gases.
- It is important to know what the procedures are for operating the engine. Are they running then engine up to operating temperature once a week, bi-weekly, or once a month? Do they get it up to operating temperature so that all moisture is burnt off? If they just get the oil hot enough to expand the oil then shut the engine off and the oil contracts this will not burn off moisture. Over time this will cause nitric acid to form.
- Is there an air or electric starter on the engine? If it is an electrical starter then do they have an automatic battery charger on the system? It will eat it alive.
- An engine manufacturer was having a problem with their engines. They couldn't understand why they were getting eaten up. They had hooked up two starters on this engine, one on each side, and grounded the starters on each side of the engine block. These must be grounded to one side of the engine and not the block.
Print this Technical Bulletin (PDF - 89K)
Quick Links
Top
News
POLARIS Laboratories® Expands into Central America
POLARIS Laboratories® is again extending its global reach with a new laboratory in Guatemala City. The expansion supports the company's global strategy for continued growth and is indicative of the strength and potential of the Central American market.
POLARIS Laboratories® Makes Inc. 5000 List Third Year in a Row
For the third year in a row, POLARIS Laboratories® has been named to Inc. Magazine's List of 5000 Fastest Growing Privately-Held Companies in America.
Training
Nashville
Cooling Systems Maintenance
March 6, 2012Nashville
Oil Analysis
March 7-8, 2012Houston
Cooling Systems Maintenance
April 17, 2012
Tradeshows & Conferences
UMA Motorcoach Expo
Long Beach, CA
February 8-12, 2012PepsiCo Summit & Tradeshow
San Antonio, TX
February 13-16, 2012
Secondary Navigation
